Connect with us

News

SpaceX’s first high-altitude Starship gets ready to prove itself

SpaceX has begun installing functional aerodynamic control surfaces on a Starship prototype for the first time. (NASASpaceflight - bocachicagal)

Published

on

SpaceX has begun outfitting its first high-altitude Starship prototype with the basis of functional aerodynamic flaps, potentially paving the way for the ship’s first crucial proof test(s) in the near future.

Unsurprisingly, the first real attempt to install the functional ‘flaps’ Starships will use to fall back to Earth and land has been (relatively) slow going. The tank and engine section of Starship serial number 8 (SN8) – the high-altitude prototype-to-be – was stacked to its full height around August 27th. Shorthand for curved steel sections meant to make Starships more aerodynamic and protect sensitive mechanisms, the first signs of functional ‘aerocovers’ arrived in Boca Chica a few days later on August 31st.

Aerocover ‘caps’ arrived in Boca Chica in mid-August. (NASASpaceflight – bocachicagal)
Long shrouds arrived in mid-September. (NASASpaceflight – bocachicagal)
A possible aerocover installation jig or flap frame. In the foreground, SpaceX already has several pairs of flaps on hand whenever SN8 is ready for them. (NASASpaceflight – bocachicagal)

A much longer aerocover appeared on September 11th and SpaceX appeared to begin installing it on Starship SN8 around September 14th, temporarily tack-welding it to the rocket’s hull. SpaceX may be using a sort of alignment jig (bottom photo above) to ensure that the extremely thin and flexible steel covers are easily installed in a uniform fashion where they’re supposed to be.

If not, the LEGO-esque structure could also be a rudimentary frame for Starship’s aft flaps – heavy and inefficient but extremely cheap and easy to build and tweak. Most of that work is being done inside SpaceX’s Starship assembly building, largely hidden from sight from public perspectives, so it’s hard to say anything with certainty until SN8 rolls out for the first time.

A closer view of the Starship SN8’s first aerocover. (NASASpaceflight – bocachicagal)
Starship SN7.1 is still awaiting its destructive end. (NASASpaceflight – bocachicagal)
SpaceX is already preparing for what comes after SN7.1, however. (NASASpaceflight – bocachicagal)

When that milestone will come is unclear, likely to the extent that even SpaceX isn’t sure. Currently, it’s unknown if SpaceX will fully outfit Starship SN8 with a nosecone and all four flaps before putting the prototype through its first proof tests – possibly up to and including the first static fire test with three Raptor engines. Starship SN8 is the first full-size prototype built out of a new steel alloy and while that alloy is currently being tested to its limits by test tank SN7.1, proving SN8’s integrity first would save a lot of time and effort in the event that SpaceX has more to learn about the limits of 304L steel and the ship fails during basic testing.

If SpaceX chooses to perform a cryogenic proof test prior to fully installing flaps and a nosecone, Starship SN8 could feasibly roll to the launch pad well before the end of the month. In fact, SpaceX moved a hydraulic ram used to simulate Raptor thrust back to the main test stand – where SN8 will likely undergo its first tests – on September 19th. Typically, that ram has been installed just days before a Starship is transported from factory to launch pad.

In the event that SpaceX chooses to perform a cryo proof test and/or static fire prior to fully integrating Starship SN8, the ship could likely be easily moved back to the factory to have its nosecone and flaps installed. Either way, chances are good that SN8 will be ready to head to the launch pad for its first test campaign within the next two weeks.

Advertisement

Check out Teslarati’s Marketplace! We offer Tesla accessories, including for the Tesla Cybertruck and Tesla Model 3.

Eric Ralph is Teslarati's senior spaceflight reporter and has been covering the industry in some capacity for almost half a decade, largely spurred in 2016 by a trip to Mexico to watch Elon Musk reveal SpaceX's plans for Mars in person. Aside from spreading interest and excitement about spaceflight far and wide, his primary goal is to cover humanity's ongoing efforts to expand beyond Earth to the Moon, Mars, and elsewhere.

Advertisement
Comments

News

Tesla is overhauling its Full Self-Driving subscription for easier access

The subscription model is more accessible to many owners, as it is reasonably priced and offers the option to take a month off from using it if they are interested in saving money.

Published

on

Credit: Tesla

Tesla is overhauling its Full Self-Driving subscription and how it markets it to customers after several owners and fans of the company complained about the accessibility of the monthly access to its driver assistance suite.

Tesla Full Self-Driving is the automaker’s semi-autonomous driving suite, which is widely regarded as the most robust and capable on the market today. Owners can purchase the suite outright for $8,000, or they can subscribe to the program for $99 per month, an option it enabled a few years ago.

However, it is not super easy to subscribe to the subscription model, nor is it even recognized on the company’s Online Design Studio. Without some research or prior knowledge, a consumer might not even know they could pay monthly to experience Full Self-Driving.

That is set to change, according to Tesla’s AI/IT Infrastructure, Cybersecurity, IT Apps, and Vehicle Service head Raj Jegannathan, who said the company is planning to change that.

Instead of having customers only have the option to pay outright for the suite, Tesla is now planning to offer the subscription model in its Online Design Studio, making it easier to activate that option:

It will be the second major change Tesla makes to how it sells Full Self-Driving to customers, the first being videos of real-life operation of FSD in the Design Studio. Previously, the site only showed animations of Full Self-Driving’s capabilities.

Tesla added the videos of FSD handling some tricky situations, as well as general operation of the suite, to the Design Studio in recent weeks.

Tesla makes big change to encourage Full Self-Driving purchases

The subscription model is more accessible to many owners, as it is reasonably priced and offers the option to take a month off from using it if they are interested in saving money.

Many cannot justify paying for the suite outright, especially as it adds $8,000 to the cost of their car. After they experience its capabilities for themselves, they might.

Both moves appear to be an effort to increase the take rate of Full Self-Driving, particularly as autonomy takes center stage at Tesla.

With the rollout of Robotaxi and some teased capabilities of the upcoming v14 iteration of Full Self-Driving, Tesla is gearing up to continue advancing its self-driving technology.

Continue Reading

News

Tesla talks Semi ramp, Optimus, Robotaxi rollout, FSD with Wall Street firm

Published

on

Credit: Tesla

Tesla (NASDAQ: TSLA) recently talked about a variety of topics with Wall Street firm Piper Sandler, as the firm released a new note on Friday about their meeting with the company’s Investor Relations team.

According to the note from Piper Sandler, Tesla talked in detail about the Semi program, Optimus, and its potential valuation given its capabilities, the rollout of Robotaxi in Austin, and Full Self-Driving progress in the United States.

Tesla Semi Ramp

The Tesla Semi is set to enter mass production in 2026 at a dedicated factory near the company’s Gigafactory in Reno, Nevada.

The Semi has already been in pilot program testing, as Tesla has partnered with a few companies, like Frito-Lay and PepsiCo., to perform regional logistics. It has been met with excellent reviews from drivers, and it has helped give Tesla a good idea of what to expect when it makes its way to more companies in the coming years.

Piper Sandler said that it is evident Tesla is preparing for a “major ramp,” but it is keeping its expectations low:

“We’ve never expected much from this product, but we’d love to be proven wrong (Tesla is clearly prepping for a major ramp).”

Tesla Optimus and its value internally and externally

Optimus has been working in Tesla factories for some time, but its expectations as a product offering outside of the company internally have major implications.

Its role within Tesla factories, for now, is relatively low, but Optimus is still doing things to assist. By this time next year, Piper Sandler said Optimus should have bigger responsibilities:

“By this time in 2026, Optimus should be moving/staging parts within Tesla’s facilities.”

Outside of Tesla, Optimus could be a major beneficiary for companies as it could be a more affordable way to handle tedious tasks and manual labor. The firm believes that if Optimus can work 18-hour shifts, a cost of $100,000 per unit “would be justified.”

Tesla Robotaxi Expansion

The big focus of the firm with Robotaxi was Tesla’s expansion of the geofence in Austin this week. It was substantial, bringing the Robotaxi’s total service area to around 170 square miles, up from the roughly 90 square miles that rival Waymo is offering in the city.

Tesla Robotaxi geofence expansion enters Plaid Mode and includes a surprise

Tesla has doubled its geofence three times since its launch in late June, and it also revealed that its fleet of vehicles has expanded by 50 percent. It did not give a solid number of how many vehicles are operating in the fleet.

Tesla Full Self-Driving v14 launch

Tesla’s Full Self-Driving suite is set to have a fresh version, v14, rolled out in either September or October, and there are some pretty high expectations for it.

CEO Elon Musk said:

“The FSD release in about 6 weeks will be a dramatic gain with a 10X higher parameter count and many other improvements. It’s going through training & testing now. Once we confirm real-world safety of FSD 14, which we think will be amazing, the car will nag you much less.”

There is also some expectation that v14 could be the public release of what Tesla is running in Austin for Robotaxi. The firm confirmed this in their note by stating it “should enable Tesla owners to use software that is on par with Robotaxis in Austin.”

The only real hold up would be regulator skepticism, but Tesla can alleviate this with strong data.

The firm maintained its ‘Overweight’ rating and the $400 price target it holds on the stock.

Continue Reading

News

Tesla starts Full Self-Driving rollout to owners in Australia

“To have this car drive me around Brisbane for an hour, we’re talking in the city, motorway, spaghetti bowl of on-ramps, it handled it so well. It was mind-blowing.”

Published

on

Credit: Tesla

Tesla has already started rolling out its Full Self-Driving suite to owners in Australia after officially launching the driver assistance suite in the country yesterday.

Earlier this week, Tesla seemed to be moving toward the launch of Full Self-Driving (Supervised) in Australia after numerous media members received early access to test its performance.

Tesla officially launched Full Self-Driving (Supervised) in Australia yesterday. The company told media members who got early access to the suite that the rollout would begin with Hardware 4-equipped Model 3 and Model Y vehicles.

Tesla launches Full Self-Driving in a new region

The release would be slow and gradual, with the process performed in stages.

The first stage of the rollout has already begun in Australia:

Tesla is reminding drivers in Australia who are using the suite for the first time that they must not become complacent while FSD is in operation. It is not fully autonomous and still requires the driver to remain attentive to road conditions and the vehicle’s surroundings.

Currently, the suite is only available to purchase outright, and it comes at a cost of $10,100. A subscription model is in the works, similar to the one in the United States, but Tesla has not yet announced its plans or pricing model for this.

Australia is the sixth country to receive Full Self-Driving (Supervised), or at least some version of it, as the United States, Canada, Mexico, China, and Puerto Rico all have access to the suite currently. In China, it is slightly different and is referred to as “City Autopilot” due to regulatory boundaries.

Early reviews of the suite have been very strong, as local media have also had the opportunity to try it, with one journalist saying, To have this car drive me around Brisbane for an hour, we’re talking in the city, motorway, spaghetti bowl of on-ramps, it handled it so well. It was mind-blowing.”

Continue Reading

Trending