News
SpaceX fires up redesigned Crew Dragon as NASA reveals SuperDraco thruster “flaps”
On November 13th, SpaceX revealed that a planned static fire test of a Crew Dragon’s powerful abort thrusters was completed without issue, a strong sign that the company has successfully redesigned the spacecraft to prevent a catastrophic April 2019 explosion from reoccurring.
Pending a far more extensive analysis, Wednesday’s static fire should leave SpaceX on track to perform Crew Dragon’s next major flight test before the end of 2019.
In an unexpected flourish of transparency, SpaceX and NASA published photos of the Crew Dragon capsule’s static fire test just a few hours after it was completed, an excellent sign that the ‘quick-look’ data analysis immediately following the test was extremely positive. Spaceflight Now was first to visually confirm that the test had occurred, publishing a photo that revealed a whitish cloud of smoke produced by the static fire around 3:15 pm EST (20:15 UTC).
Had a failure similar to the April 2019 explosion occurred, that cloud would have likely been tinged red by unburnt dinitrogen tetroxide (NTO) oxidizer, and the different appearance of November 13th’s exhaust cloud was seen as the first tentative sign that this static fire had gone more successfully.
Alongside photos of the SuperDraco thruster test published by NASA and SpaceX shortly after its conclusion, SpaceX confirmed that the test was completed without issue. Regardless of whether everything performed exactly as intended, this means that factory-fresh Crew Dragon capsule C205 made it through the test unscathed, likely securing SpaceX and NASA a large volume of uninterrupted telemetry data, as well as the hardware itself.
Just hours after C205’s static fire was completed, NASA published a detailed update, confirming that the tests were finished without any immediately apparent issues.
NASA described the test in much more detail than SpaceX, noting that it began with the ignition of two of Crew Dragon’s 16 Draco maneuvering thrusters, each performing two one-second burns. C205’s eight SuperDraco abort thrusters subsequently ignited and burned for a total of ~9 seconds to simulate required abort performance, followed by the reignition of two Draco thrusters immediately after SuperDraco cutoff.
Each capable of producing several dozen pounds of thrust, both Crew and Cargo Dragon use Draco thrusters to orient themselves in orbit, rendezvous with the International Space Station, and lower their orbits to reenter Earth’s atmosphere. Crew Dragon’s Draco thrusters are also designed to control its attitude during abort scenarios, stabilizing and flipping the spacecraft to prevent a loss of control and ensure proper orientation during emergency parachute deployment. The Draco firings during Crew Dragon’s November 13th static fire were meant to simulate that additional use-case.
Aside from verifying that SpaceX has successfully redesigned Crew Dragon to mitigate the failure mode that caused capsule C201’s catastrophic explosion in April 2019, the Draco static fires specifically mirrored the burns Crew Dragon C205 will need to perform to successfully complete its In-Flight Abort (IFA) test. As noted by NASA and SpaceX, with the static fire complete, both teams will now comb through the data produced, inspect Crew Dragon to verify its health and the performance of its redesigned high-flow pressurization system, and perform any necessary refurbishment.
SuperDraco’s mystery “flaps”
NASA’s post on Crew Dragon’s static fire revealed another thoroughly intriguing detail: the SpaceX spacecraft’s SuperDraco thrusters apparently have flaps! A bit of retroactive speculation suggests that SuperDracos are closed out with plugs of some sort to create a seal against the environment before Crew Dragon is rolled out to the launch pad. Perhaps, in the event of a SuperDraco ignition, SpaceX included actuating flaps as a method of resealing those thrusters prior to splashdown in the Atlantic Ocean.
“Immediately after the SuperDracos shut down, two Dracos thrusters fired and all eight SuperDraco flaps closed, mimicking the sequence required to reorient the spacecraft in-flight to a parachute deploy attitude and close the flaps prior to reentry. The full sequence, from SuperDraco startup to flap closure, spanned approximately 70 seconds.”
NASA, November 13th, 2019
Given that the obvious utility of those flaps appears to be extremely limited and their associated actuators have to survive the 9+ consecutive seconds of hellish conditions in the event of an actual abort, it seems like an excessively complicated system to include on Crew Dragon. Nevertheless, the ability to guarantee that SuperDracos are water-sealed before splashdown would almost without a doubt make Crew Dragon far easier to refurbish and reuse.
The SuperDraco flaps may also be a holdover from before propulsive Crew Dragon landings were canceled, although the use-cases for such a system still remain unclear. The flaps’ raison d’etre could even be as simple as preventing water intrusion that might otherwise cause Dragon to sink after splashdown.
Regardless of why they exist, NASA indicates that SpaceX’s November 13th static fire proved that they worked exactly as expected, closing soon after the simulated abort burn to seal Crew Dragon against water intrusion. If NASA and SpaceX’s deep-dive inspections and data analysis uncover no red flags, it’s extremely likely that SpaceX will able to launch C205 for its In-Flight Abort test some 4-8 weeks from now.
If the IFA also goes as planned, Crew Dragon could be ready for its inaugural NASA astronaut launch as early as February or March 2020.
Check out Teslarati’s Marketplace! We offer Tesla accessories, including for the Tesla Cybertruck and Tesla Model 3.
News
Tesla just tipped its hand on a major Cybercab feature as production hits Plaid Mode
Tesla has delivered a clear signal that its Robotaxi ambitions are shifting into high gear. On April 17, longtime factory observer and drone pilot Joe Tegtmeyer captured drone footage and still images showing approximately 14 freshly built Cybercabs parked in the outbound lot—each one conspicuously lacking a steering wheel.
Tesla just tipped its hand on a major Cybercab feature as it is putting production into Plaid Mode, but a clear indication of what the company plans to do with the vehicle is now apparent.
Tesla has delivered a clear signal that its Robotaxi ambitions are shifting into high gear, and it’s doing it with full autonomy in mind.
On April 17, longtime factory observer and drone pilot Joe Tegtmeyer captured drone footage and still images showing approximately 14 newly built Cybercabs parked in the outbound lot, each conspicuously lacking a steering wheel, and potentially pedals.
Tegtmeyer’s post highlighted the significance of this development: The images and video reveal sleek, two-seat Cybercabs in their final production form: no driver controls, no side mirrors, and the minimalist interior first unveiled at Tesla’s “We Robot” event in October 2024.
Something big has changed at Giga Texas with Cybercab production … ~ 14 in the outbound lot WITHOUT STEERING WHEELS!
Earlier this week, the production line has begun what we are all waiting for and I would expect to see many more starting on Monday, 4/20 🤠
A big step… pic.twitter.com/K17ZzBlQ8k
— Joe Tegtmeyer 🚀 🤠🛸😎 (@JoeTegtmeyer) April 17, 2026
These units contrast with earlier test vehicles spotted at the factory’s crash-test area, which carried temporary steering wheels and pedals to meet current federal regulations during data-collection phases.
The outbound-lot vehicles appear complete, with production wheels, tire stickers, and the signature Cybercab styling ready for deployment.
This sighting represents a pivotal transition. Tesla designed the Cybercab from the ground up as a purpose-built robotaxi, engineered for unsupervised Full Self-Driving (FSD) operation. Removing manual controls eliminates cost, complexity, and weight while maximizing interior space and range.
The move also signals that Tesla has cleared initial validation hurdles and is now building vehicles to the exact specification intended for commercial robotaxi service.
Industry watchers note the timing aligns with Tesla’s broader rollout plans. Production of early Cybercabs began in late 2025 and early 2026, primarily for internal testing and regulatory compliance.
Federal Motor Vehicle Safety Standards currently limit vehicles without steering wheels to 2,500 units per year without exemption, a cap that Tesla is navigating through ongoing filings.
Tesla Cybercab spotted next to Model Y shows size comparison
The appearance of steering-wheel-free units in the outbound lot suggests the company is preparing a small initial fleet—likely for Austin pilot operations or further validation—while pushing for regulatory relief to scale output.
The development comes as Tesla ramps its dedicated Cybercab line at Gigafactory Texas. If the Monday surge materializes as predicted, observers expect dozens more units to accumulate rapidly.
With unsupervised FSD advancing and regulatory conversations ongoing, these wheel-less Cybercabs parked under the Texas sun represent more than hardware—they embody Tesla’s bet that autonomous mobility is no longer a prototype dream but an imminent reality.
News
Tesla preps new Model Y trim for India, a once-elusive market
Tesla’s journey into India began with significant hurdles. For years, the electric vehicle giant faced steep import tariffs ranging from 70 percent to 110 percent on fully built vehicles, which dramatically inflated prices and stalled entry plans.
Tesla is preparing to bring its newest Model Y trim to India, a once-elusive market that was hesitant to allow any vehicles built outside the market into its automotive sector.
Now, it is preparing to allow China-built Model Y vehicles to come into the country, in an effort to expand sales and offer what is a widely-requested variant to Indian customers.
Tesla’s journey into India began with significant hurdles. For years, the electric vehicle giant faced steep import tariffs ranging from 70 percent to 110 percent on fully built vehicles, which dramatically inflated prices and stalled entry plans.
Elon Musk repeatedly criticized these duties as among the world’s highest, making premium EVs like the Model Y prohibitively expensive for most buyers in the price-sensitive market.
After prolonged negotiations and multiple delays, Tesla finally debuted in July 2025 with a quiet rollout focused on luxury segments. It opened showrooms in Mumbai and New Delhi, importing standard Model Y SUVs from its Shanghai Gigafactory.
Tesla China posts strong February wholesale growth at Gigafactory Shanghai
Yet the launch proved challenging: vehicles carried sticker prices near $70,000, leading to tepid demand. Bloomberg reported only about 600 orders in the first two months, while official data showed just 227 registrations for all of 2025—far below internal targets. By early 2026, the company offered discounts of up to ₹200,000 ($2,200) to clear unsold inventory.
Now, less than a year later, Tesla is demonstrating resilience and adaptability. According to a Bloomberg report on April 17, the company is preparing to launch the Model Y L—a six-seat, long-wheelbase variant with three-row seating—as early as next week.
This marks Tesla’s first new product introduction in India since its initial entry. Notably, the newest Model Y configuration, which debuted in China in 2025 and features extended space tailored for families, will once again be exported directly from Tesla’s Shanghai Gigafactory.
The move highlights a shift from early struggles to a more targeted approach, leveraging an existing platform to better suit Indian preferences for multi-generational, spacious SUVs without committing to immediate local production.
Tesla launches in India with Model Y, showing pricing will be biggest challenge
The Model Y L’s arrival underscores Tesla’s incremental strategy amid global EV headwinds and India’s unique challenges, including limited charging infrastructure and competition from local manufacturers.
While tariffs continue to keep pricing in the premium segment, the six-seater variant aims to broaden appeal beyond early luxury adopters by addressing practical family needs.
This evolution, from battling high barriers and disappointing initial sales to exporting its latest derivative model, signals cautious optimism.
Success with the Model Y L could strengthen Tesla’s foothold in one of the world’s most populous markets and potentially pave the way for deeper investments, such as localized manufacturing, should tariff relief or policy shifts materialize.
For now, the China-to-India supply chain represents a pragmatic bridge over the very obstacles that once made entry so difficult.
Elon Musk
Tesla’s golden era is no longer a tagline
Tesla “golden era” teaser video highlights the future of transportation and why car ownership itself may be the next thing to change.
The golden age of autonomous ridesharing is arriving, and Tesla is making sure we can all picture a future that looks like the future. A recent teaser posted to X shows a Cybercab parked outside a home, and with a clear message that your everyday life may soon look like this when the driverless vehicles shows up at your door.
Tesla has begun the rollout of its Robotaxi service across US cities, and the production of its dedicated, fully-autonomous Cybercab vehicle. The first Cybercab rolled off the Giga Texas assembly line on February 17, 2026, with volume production now targeted for this month. Additionally, the Robotaxi service built around it is already running, without human drivers, in US cities.
Tesla Cybercab production ignites with 60 units spotted at Giga Texas
The Cybercab is built without a steering wheel, pedals, or side mirrors, designed from the ground up for unsupervised autonomous operation. Musk described the manufacturing approach as closer to consumer electronics than traditional car production, targeting a cycle time of one unit every ten seconds at full scale.
Drone footage from April 13, 2026 captured over 50 Cybercab units on the Giga Texas campus, with several clustered near the crash testing facility. Musk has noted that Tesla plans to sell the Cybercab to consumers for under $30,000, and owners will be able to add their vehicles to the Tesla robotaxi network when not in personal use, potentially generating income to offset the vehicle’s purchase cost. That model changes the math on vehicle ownership in a meaningful way, making a car something closer to a depreciating asset that can also earn by paying itself off and generate a profit.
During Tesla’s Q4 earnings call, the company confirmed plans to expand the Robotaxi program to seven new cities in the first half of 2026, including Dallas, Houston, Phoenix, Miami, Orlando, Tampa, and Las Vegas. The service already runs without safety drivers in Austin, and public road testing of the Cybercab has expanded to five states, including California, Texas, New York, Illinois, and Massachusetts.
Golden era pic.twitter.com/AS6pX2dK8N
— Tesla Robotaxi (@robotaxi) April 16, 2026
Tesla just tipped its hand on a major Cybercab feature as production hits Plaid Mode
Tesla preps new Model Y trim for India, a once-elusive market
