Connect with us
Munro Live shares a look at Tesla's improvements on the 4680 structural pack. Munro Live shares a look at Tesla's improvements on the 4680 structural pack.

News

Munro Live shares a look at Tesla’s improvements on the 4680 structural pack.

Photo Credit: Munro Live/YouTube

Published

on

In the latest video from Munro Live, Sandy Munro’s team goes over some improvements that Tesla made to its 4680 structural pack. In the video, they talk about the improved cell interconnects, current collector layout, voltage sensor harness, and battery management system.

Antonio DiNunno and Cory Steuben started off the video with a look at the top of the Model Y’s battery pack. In particular, the duo was analyzing the current collectors.

Antonio quickly explained what all of this meant for viewers tuning in. The nine cells were grouped together in parallel. He also pointed out something a bit different.

“We’re seeing a grouping of nine cells in parallel. So if you follow the positives along the current collector, you’ll get nine. And they’re alternating so you have one on this side and two on this side. It gives us the odd number.”

“We’re also seeing–what is a little bit different–a bit of a combination of the Plaid bonding with the Model 3/Model Y current collector strategy is the current collector is welded directly to the cells themselves.”

Advertisement
-->

“So it removes failure that was normally present when you had current collector to cell bonding with the wire bonds.

From 40-something cells in parallel to 9 cells in parallel.

The team noted that the previous current collector had smaller bonds for the Model Y and the Model 3. There were roughly 40-something cells in parallel.

“So you reduce the number of cells in parallel so you have nine. Each one is handling more load. More current.”

The team pointed out that the welds are larger and the copper voltage sensor harness welds from the battery management board to the actual brick.

The Munro Live team also noted that the pink polyurethane could have been a spillover from passing through the small triangles. There was also a thin layer of what looked like PCBA.

Advertisement
-->

“Tesla did some integration where the current collector itself is adhered to the PCBA which is then adhered to the top plastic cover. So, in effect, you get a crop in place part. It’s almost impossible to misalign.”

Murno Live: “A very good strategy overall”

Aside from the pink urethane foam “of death,” Antonio said that this was a very good strategy overall.

“They connect to three terminals on the ends so disconnecting the entire pack or module–I believe the term is array that we’re using for this–is a lot easier.”

The video goes on to cover other details and improvements of the 4680 battery cells. You can watch the full video below.

Advertisement
-->

Johnna Crider is a Baton Rouge writer covering Tesla, Elon Musk, EVs, and clean energy & supports Tesla's mission. Johnna also interviewed Elon Musk and you can listen here

Advertisement
Comments

Cybertruck

Tesla made a change to the Cybertruck and nobody noticed

Published

on

Credit: diagnosticdennis/Instagram and @smile__no via Tesla Owners of Santa Clarita Valley/X

Tesla made a change to the Cybertruck, and nobody noticed. But to be fair, nobody could have, but it was revealed by the program’s lead engineer that it was aimed toward simplifying manufacturing through a minor change in casting.

After the Cybertruck was given a Top Safety Pick+ award by the Insurance Institute for Highway Safety (IIHS), for its reputation as the safest pickup on the market, some wondered what had changed about the vehicle.

Tesla Cybertruck earns IIHS Top Safety Pick+ award

Tesla makes changes to its vehicles routinely through Over-the-Air software updates, but aesthetic changes are relatively rare. Vehicles go through refreshes every few years, as the Model 3 and Model Y did earlier this year. However, the Cybertruck is one of the vehicles that has not changed much since its launch in late 2023, but it has gone through some minor changes.

Most recently, Wes Morrill, the Cybertruck program’s Lead Engineer, stated that the company had made a minor change to the casting of the all-electric pickup for manufacturing purposes. This change took place in April:

Advertisement
-->

The change is among the most subtle that can be made, but it makes a massive difference in manufacturing efficiency, build quality, and scalability.

Morrill revealed Tesla’s internal testing showed no difference in crash testing results performed by the IIHS.

The 2025 Cybertruck received stellar ratings in each of the required testing scenarios and categories. The Top Safety Pick+ award is only given if it excels in rigorous crash tests. This requires ‘Good’ ratings in updated small and moderate overlap front, side, roof, and head restraints.

Advertisement
-->

Additionally, it must have advanced front crash prevention in both day and night. Most importantly, the vehicle must have a ‘Good’ or ‘Acceptable’ headlights standard on all trims, with the “+ ” specifically demanding the toughest new updated moderate overlap test that checks rear-seat passenger protection alongside driver safety.

Continue Reading

News

Tesla enters interesting situation with Full Self-Driving in California

Published

on

tesla model x
A Tesla Motors Inc Model X is seen at Tesla's introduction of its new battery swapping program in Hawthorne, California June 20, 2013. Tesla Motors Inc on Thursday unveiled a system to swap battery packs in its electric cars in about 90 seconds, a service Chief Executive Elon Musk said will help overcome fears about their driving range. REUTERS/Lucy Nicholson (UNITED STATES - Tags: TRANSPORT BUSINESS LOGO) - RTX10VSH

Tesla has entered an interesting situation with its Full Self-Driving suite in California, as the State’s Department of Motor Vehicles had adopted an order for a suspension of the company’s sales license, but it immediately put it on hold.

The company has been granted a reprieve as the DMV is giving Tesla an opportunity to “remedy the situation.” After the suspension was recommended for 30 days as a penalty, the DMV said it would give Tesla 90 days to allow the company to come into compliance.

The DMV is accusing Tesla of misleading consumers by using words like Autopilot and Full Self-Driving on its advanced driver assistance (ADAS) features.

The State’s DMV Director, Steve Gordon, said that he hoped “Tesla will find a way to get these misleading statements corrected.” However, Tesla responded to the story on Tuesday, stating that this was a “consumer protection” order for the company using the term Autopilot.

It said “not one single customer came forward to say there’s a problem.” It added that “sales in California will continue uninterrupted.”

Advertisement
-->

Tesla has used the terms Autopilot and Full Self-Driving for years, but has added the term “(Supervised)” to the end of the FSD suite, hoping to remedy some of the potential issues that regulators in various areas might have with the labeling of the program.

It might not be too long before Tesla stops catching flak for using the Full Self-Driving name to describe its platform.

Advertisement
-->

Tesla Robotaxi goes driverless as Musk confirms Safety Monitor removal testing

The Robotaxi suite has continued to improve, and this week, vehicles were spotted in Austin without any occupants. CEO Elon Musk would later confirm that Tesla had started testing driverless rides in Austin, hoping to launch rides without any supervision by the end of the year.

Continue Reading

Investor's Corner

Tesla stock closes at all-time high on heels of Robotaxi progress

Published

on

Credit: Tesla

Tesla stock (NASDAQ: TSLA) closed at an all-time high on Tuesday, jumping over 3 percent during the day and finishing at $489.88.

The price beats the previous record close, which was $479.86.

Shares have had a crazy year, dipping more than 40 percent from the start of the year. The stock then started to recover once again around late April, when its price started to climb back up from the low $200 level.

Advertisement
-->

This week, Tesla started to climb toward its highest levels ever, as it was revealed on Sunday that the company was testing driverless Robotaxis in Austin. The spike in value pushed the company’s valuation to $1.63 trillion.

Tesla Robotaxi goes driverless as Musk confirms Safety Monitor removal testing

It is the seventh-most valuable company on the market currently, trailing Nvidia, Apple, Alphabet (Google), Microsoft, Amazon, and Meta.

Shares closed up $14.57 today, up over 3 percent.

The stock has gone through a lot this year, as previously mentioned. Shares tumbled in Q1 due to CEO Elon Musk’s involvement with the Department of Government Efficiency (DOGE), which pulled his attention away from his companies and left a major overhang on their valuations.

Advertisement
-->

However, things started to rebound halfway through the year, and as the government started to phase out the $7,500 tax credit, demand spiked as consumers tried to take advantage of it.

Q3 deliveries were the highest in company history, and Tesla responded to the loss of the tax credit with the launch of the Model 3 and Model Y Standard.

Additionally, analysts have announced high expectations this week for the company on Wall Street as Robotaxi continues to be the focus. With autonomy within Tesla’s sights, things are moving in the direction of Robotaxi being a major catalyst for growth on the Street in the coming year.

Continue Reading