

News
SpaceX breaks Starship test record, rolls next booster to launch pad
SpaceX has completed a record-breaking test of a Starship booster and rolled a newer Super Heavy prototype to the launch pad just hours apart.
Almost six weeks after SpaceX began Super Heavy Booster 7’s static fire test campaign, the company has broken new ground by simultaneously igniting seven Raptor engines at once. A matter of hours later, confirming SpaceX CEO Elon Musk’s plans in real time, the company transported a second Super Heavy prototype (Booster 8) from the factory to the launch pad, where it joined Booster 7.
According to Musk, those rockets will soon switch places, ensuring that no time is wasted while SpaceX continues to gradually work towards Starship’s first orbital launch attempts.
Booster 7 kicked off the most important stage of its flight qualification process on August 9th and 11th with two back-to-back static fires, each igniting just one of 20 installed Raptor engines. Both appeared to be successful and SpaceX returned B7 to its Boca Chica, Texas factory, reinstalled a full set of 33 engines, and sent the Super Heavy back to the launch pad two weeks later.
On August 31st, SpaceX attempted to ignite three of Booster 7’s 33 Raptors. One engine failed to ignite but the others did not, resulting in a mostly successful two-engine test. Over the next two weeks, SpaceX performed several ignition-free ‘spin-prime’ tests, two of which appeared to spin up all 33 engines without causing an explosion. Finally, SpaceX telegraphed its next major goal with a seven-engine spin-prime test on September 16th and another (albeit with a slightly different set of engines) on September 19th.
Shortly after the second seven-engine spin-prime, SpaceX refilled Booster 7 with propellant, went back through the same procedures, and ignited the same seven engines for about five seconds. No obvious issues arose and Musk later implied that the test went well. It set a new record for the largest number of Raptors simultaneously ignited on a single prototype and likely also broke the record for most thrust produced by a vehicle tested at Starbase.
If all seven upgraded Raptor V2 engines were operating at full throttle, they could have briefly produced more than 1600 tons (~3.6M lbf) of thrust – roughly equivalent to two Falcon 9 boosters. Measuring about 69 meters (~225 ft) tall and 9 meters (~30 ft) wide, Super Heavy will be the most powerful liquid rocket booster ever tested once it ignites as few as 20 of its 33 engines at full thrust.
In an increasingly rare update, Musk revealed that SpaceX will once again return Booster 7 to Starbase’s factory for mysterious “robustness upgrades” after the latest round of testing. Musk doesn’t seem to think that those upgrades will take very long, and anticipates that Starbase’s “next big test” will be the first complete wet dress rehearsal of a fully-assembled two-stage Starship, followed by Super Heavy’s first 33-engine static fire test, “in a few weeks.”
More likely than not, each step of that process will take multiple attempts and uncover issues that will then need to be corrected and verified over the course of several months. But with Starship 24 having already completed a full six-engine static fire, there’s a small chance SpaceX will find itself with a fully-stacked Starship that is more or less ready for its first orbital launch attempt by the end of October.
In the meantime, after Booster 7 returns to the factory, Booster 8 – finally complete after a relatively slow six-month assembly – will kick off basic proof testing at SpaceX’s South Texas orbital launch site. SpaceX wasted no time preparing for that swap and transported Booster 8 to the pad just seven hours after Booster 7’s seven-engine static fire. If things move more smoothly than they did with B7, it’s possible that B8 will complete proof testing and be ready to head back to the factory for Raptor installation by the time B7’s upgrades are finished – a very efficient transition if it works out that way.
News
SpaceX aces Starship test flight 10 with successful payload deployment
The mission began at 6:30 p.m. local time in Starbase, Texas, when the launch of Starship initiated. After about eight minutes, stage separation was completed, and the Super Heavy Booster headed back down to Earth for a planned splashdown in the Indian Ocean:

SpaceX aced its tenth Starship test flight on Tuesday night after multiple delays pushed the mission back to this evening. Originally scheduled for Sunday night, SpaceX had two delays push the flight back to Tuesday, which ultimately provided ideal conditions for a launch attempt.
The tenth test flight of Starship had several objectives, including a successful splashdown of the booster in the Gulf of America, the deployment of eight Starlink simulation modules from the PEZ dispenser, and a splashdown of the ship in the Indian Ocean.
SpaceX successfully achieved all three of these objectives, making it one of the most successful test flights in the Starship program. There was no attempt to catch the booster this evening, as the company had been transparent about it ahead of the launch.
The mission began at 6:30 p.m. local time in Starbase, Texas, when the launch of Starship initiated. After about eight minutes, stage separation was completed, and the Super Heavy Booster headed back down to Earth for a planned splashdown in the Indian Ocean:
Super Heavy has splashed down in the Gulf pic.twitter.com/LGozUAmLt8
— SpaceX (@SpaceX) August 26, 2025
Starship was then the main focus of the rest of the broadcast as it completed its ascent burn and coasted through space, providing viewers with spectacular views as the mission headed toward new territory, including the deployment of Starlink simulators. This would be the first time SpaceX would attempt a payload deployment.
The deployment works like a PEZ dispenser, as the simulators were stacked on top of one another and would exit through a small slit one at a time.
This occurred roughly 20 minutes into the mission:
Open the pod bay door, HAL
Starship deploying @Starlink simulator sats pic.twitter.com/3CSOyulzcJ
— SpaceX (@SpaceX) August 26, 2025
An hour and six minutes into the flight, Starship reached its final destination, which was the Indian Ocean. A successful splashdown would bring closure to Starship’s tenth test flight, marking the fifth time a test flight in the program’s history did not end with vehicle loss.
It was also the first of four test flights this year that will end with Starship being recovered.
Splashdown confirmed! Congratulations to the entire SpaceX team on an exciting tenth flight test of Starship! pic.twitter.com/5sbSPBRJBP
— SpaceX (@SpaceX) August 27, 2025
SpaceX is expected to launch Starship again in approximately eight weeks, pending the collection of data and other key metrics from this flight.
News
WATCH: SpaceX attempts Starship’s tenth test flight after two delays
This evening, SpaceX has already stated that conditions appear to be approximately 45 percent favorable for launch. This is ten percent less than last night, when the mission was eventually scrapped around 7 p.m. local time.

SpaceX is set to launch Starship tonight, provided the weather cooperates and everything with the ship goes smoothly.
This is SpaceX’s third attempt to launch Starship for its tenth test flight, with Sunday’s and Monday’s attempts both being scrapped due to a leak and unfavorable weather conditions on the respective days.
This evening, SpaceX has already stated that conditions appear to be approximately 45 percent favorable for launch. This is ten percent less than last night, when the mission was eventually scrapped around 7 p.m. local time.
Propellant load of the upper stage and Super Heavy booster is already underway, and the launch is expected to occur at 6:30 p.m. in Starbase, Texas.
You can watch the tenth test flight of Starship below via SpaceX:
Watch Starship’s tenth flight test → https://t.co/UIwbeGoo2B https://t.co/BFrpQPQFUw
— SpaceX (@SpaceX) August 26, 2025
News
Tesla one-ups Waymo once again with latest Robotaxi expansion in Austin
Tesla’s new Robotaxi geofence measures roughly 171 square miles of Austin’s downtown and suburbs. This is more than double the size of Waymo’s geofence, which measures 90 square miles.

Tesla’s expansion of the Robotaxi geofence on Tuesday morning was a one-up on Waymo once again, as the automaker’s service area growth helps eclipse its rival in an intense back-and-forth.
A lot of conversation has been made about Tesla’s rivalry with Waymo in terms of the capabilities of its driverless ride-sharing service in Austin, Texas.
The two companies have sparred with one another, answering each other’s expansion, and continuing to compete, all to the benefit of consumers in the region.
Tesla expanded the geofence of Robotaxi once again this morning, and it is another growth that catapults it past Waymo’s service area in Austin — this time by a considerable margin.
Comparison of Tesla’s vs Waymo’s Robotaxi geofence map in Austin, Texas.
Today, @Tesla again massively expanded their geofence area, making it significantly bigger than Waymo’s. pic.twitter.com/tHLJ2qabZJ
— Sawyer Merritt (@SawyerMerritt) August 26, 2025
Tesla’s new Robotaxi geofence measures roughly 171 square miles of Austin’s downtown and suburbs. This is more than double the size of Waymo’s geofence, which measures 90 square miles.
On July 14, Tesla officially overtook Waymo in terms of service area in Austin. But just a few days later, Waymo had responded with a bold statement, expanding from 37 square miles to 90 square miles.
Sarfraz Maredia, Global Head of Autonomous Mobility & Delivery at Uber, said the move “unlock[ed] another key milestone in Austin as our operating territory with Waymo expands from 37 to 90 square miles, which means that even more riders can experience Waymo’s fully autonomous vehicles through the Uber app.”
Tesla did not respond immediately, but it took its time with validation vehicle testing in the Austin suburbs, as we reported yesterday:
Tesla looks to expand Robotaxi geofence once again with testing in new area
Today’s expansion is perhaps the biggest step Tesla has taken in its efforts to continue to grow its Robotaxi platform. This is not only because the company has significantly expanded the size of the geofence, but also because it has ventured into suburban areas and even included Gigafactory Texas in its service area.
Waymo could come up with another timely response as it did when Tesla expanded in late July. We’ll wait to see what it comes up with, as this awesome competition between the two companies is accelerating innovation.
-
Elon Musk4 days ago
Elon Musk takes aim at Bill Gates’ Microsoft with new AI venture “Macrohard”
-
Elon Musk2 days ago
Elon Musk argues lidar and radar make self driving cars more dangerous
-
News3 days ago
Tesla offers new feature to save battery and reduce phantom drain
-
News1 week ago
Tesla Model Y L officially launched: price, features, and more
-
News6 hours ago
WATCH: SpaceX attempts Starship’s tenth test flight after two delays
-
News2 weeks ago
Tesla flexes its most impressive and longest Full Self-Driving demo yet
-
News2 weeks ago
Tesla Model Y L spotted in Europe ahead of expected September China launch
-
News6 days ago
Tesla offers new deal on used inventory that you won’t want to pass up