Connect with us

SpaceX

SpaceX reinstalls Mr Steven’s arms for Sunday Falcon 9 fairing catch

Published

on

Over the course of less than half a day, SpaceX recovery technicians completed installation of three of Mr. Steven’s four fairing recovery arms, and the final arm and net are now set to be attached to the ship by the end of tomorrow, leaving plenty of time for Mr. Steven to attempt a Falcon fairing recovery this Sunday.

The reason for the delay is unclear, but SpaceX’s next launch and Mr. Steven’s next attempt at catching a Falcon fairing slipped 24 hours to 7:21 pm, October 7 (02:21 UTC, Oct. 8). Set to place Earth-observation satellite SAOCOM-1A into a low Earth orbit, this mission will mark SpaceX’s 16th reuse of Falcon 9 boosters in 18 months, as well as the operational debut of the company’s West Coast landing zone.

Prior to attaching three arms and six of eight suspension booms, SpaceX’s recovery technicians spent the majority of October 1st and 2nd assembling Mr. Steven’s arms and situating them for installation, including the introduction of a new attachment jig of some sort. Likely used to safely rotate the arms into a position where traditional harnesses can then be used to lift them for installation, technicians spent several hours repeatedly picking up and setting down Mr Steven’s recovery components, swapping between the square jig and harnesses for each arm.

Advertisement

Additionally, a lone diver was spotted working near Mr. Steven’s stern off of a small utility boat equipped for underwater welding, presumably performing routine maintenance or repairs on the vessel’s hull and screws (propellers).

 

Once those various tasks were completed, SpaceX installed 3 of 4 arms over a period of roughly 8 hours on Wednesday, wrapping up around sunset after working through an unusual bout of rain in the Port of L.A. Despite having disappeared from Mr. Steven and Berth 240 for more than a month and a half, the vessel’s arms and booms appear almost entirely unchanged aside from visible shipping labels and the installation of small rings at the center of each arm, most likely a simple aid for organizing the rigging needed to operate his fairing catcher net.

In early August, SpaceX spent a day or two testing Mr. Steven’s arms and net with an actual Falcon fairing half, demonstrating just how flexible the combination can be. Along with motorized rigging, Mr. Steven can quickly and safely drop an ~800 kg fairing half onto its deck while also precisely controlling the net’s tension.

 

Advertisement

Speaking on October 3rd, SpaceX VP of Build and Launch Reliability Hans Koenigsmann expressed confidence that SpaceX would be able to close the loop and begin recovering fairings soon, and confirmed that the company still plans to conduct controlled drop tests with fairings later this year while continuing to attempt to catch fairing halves after SpaceX’s Vandenberg launches. Overall, Koenigsmann was visibly excited about the successes SpaceX’s fairing recovery team have already secured.


For prompt updates, on-the-ground perspectives, and unique glimpses of SpaceX’s rocket recovery fleet check out our brand new LaunchPad and LandingZone newsletters!

Advertisement

Eric Ralph is Teslarati's senior spaceflight reporter and has been covering the industry in some capacity for almost half a decade, largely spurred in 2016 by a trip to Mexico to watch Elon Musk reveal SpaceX's plans for Mars in person. Aside from spreading interest and excitement about spaceflight far and wide, his primary goal is to cover humanity's ongoing efforts to expand beyond Earth to the Moon, Mars, and elsewhere.

Advertisement
Comments

News

SpaceX and Elon Musk share insights on Starship Ship 36’s RUD

Starship Ship 36 experienced a Rapid Unscheduled Disassembly during a static fire attempt.

Published

on

Elon Musk and SpaceX provided an explanation for the Rapid Unscheduled Disassembly (RUD) of Starship Ship 36 on Wednesday. As per Musk, preliminary data suggests that a nitrogen composite overwrapped pressure vessel (COPV) in the vehicle’s payload bay failed below its proof pressure.

On Wednesday evening, Ship 36 experienced a RUD during a static fire attempt. Videos of the incident that were shared online showed Starship Ship 36 exploding into a massive fireball at its launchpad in Starbase, Texas. Images taken in the aftermath of the explosion showed significant damage to the plumbing in the area. The site’s pad structure was also destroyed.

Elon Musk shared some information immediately after the incident. In a response to a post from space enthusiast @Erdayastronaut, Musk stated that “Preliminary data suggests that a nitrogen COPV in the payload bay failed below its proof pressure.”

Musk also noted that, “If further investigation confirms that this is what happened, it is the first time ever for this design.”

SpaceX provided more insight into the incident in a post on its official website.

Advertisement

“After completing a single-engine static fire earlier this week, the vehicle was in the process of loading cryogenic propellant for a six-engine static fire when a sudden energetic event resulted in the complete loss of Starship and damage to the immediate area surrounding the stand.

“The explosion ignited several fires at the test site, which remains clear of personnel and will be assessed once it has been determined to be safe to approach. Individuals should not attempt to approach the area while safing operations continue,” SpaceX wrote in its post.

SpaceX highlighted that despite Starship Ship 36’s RUD, the incident will not result in any hazards to the surrounding communities in the Rio Grande Valley. And in a post on X, SpaceX also confirmed that everyone in the Starship team was safe and accounted for after Ship 36’s explosion.

While Ship 36’s RUD is a speed bump for the Starship program, SpaceX is a company that is known to grow stronger with every adversity. Thus, it would not be surprising if SpaceX implemented numerous improvements to Starship after this incident–improvements that would make the vehicle more reliable and safer than before.

Advertisement
Continue Reading

Elon Musk

SpaceX President meets India Minister after Starlink approval

Starlink’s India debut gets a boost as Gwynne Shotwell meets Comms Minister Scindia. Talks focused on Digital India’s goals.

Published

on

Starlink-router-fcc-approval-dish-upgrades

 

SpaceX’s Starlink India expansion gained momentum as SpaceX President and COO Gwynne Shotwell met with Communications Minister Jyotiraditya Scindia on Tuesday, following the company’s recent telecom license approval. The discussions focused on satellite communications to advance Digital India’s connectivity goals.

“Had a productive meeting with Ms. Gwynne Shotwell, President & COO of SpaceX, on India’s next frontier in connectivity. We delved into opportunities for collaboration in satellite communications to power Digital India’s soaring ambitions and empower every citizen across the country,” Scindia said.

India’s Communications Minister emphasized the transformative potential of satellite technologies, while Shotwell expressed gratitude for the license. Scindia noted: “Ms. Shotwell appreciated the license granted to Starlink, calling it a great start to the journey.”

Starlink India cleared a major regulatory hurdle after the Department of Telecommunications granted it a Global Mobile Personal Communication by Satellite (GMPCS) license. SpaceX secured the approval after a three-year wait.

Advertisement

In April, Starlink executives, including Vice President Chad Gibbs and Senior Director Ryan Goodnight, met Commerce Minister Piyush Goyal to discuss investments and partnerships, laying the groundwork for market entry. India’s satellite internet sector is heating up, with Eutelsat OneWeb and Reliance Jio also securing licenses, while Amazon’s Kuiper awaits approval.

Starlink India’s license enables SpaceX to initiate commercial operations within two months. The service will reportedly offer high-speed internet for ₹3,000 per month with unlimited data, requiring a ₹33,000 hardware kit, including a dish and router, targeting underserved and remote regions.

Starlink’s entry into India builds on its global network of over 7,000 satellites, designed to deliver low-latency internet to areas with limited broadband access. The company’s collaboration with Indian authorities and telecom giants like Reliance Jio and Bharti Airtel for distribution underscores its commitment to bridging the digital divide.

As Starlink prepares to launch services, its discussions with Scindia signal deepening ties with India’s government to support Digital India’s vision. “Satellite technologies are relevant and transformative,” Scindia noted, highlighting their role in empowering citizens. Starlink’s India expansion positions it to compete in a growing market, driving innovation and connectivity for millions in rural and remote areas.

 

Advertisement
Continue Reading

News

SpaceX Ax-4 Mission prepares for ISS with new launch date

SpaceX, Axiom Space, and NASA set new launch date for the Ax-4 mission after addressing ISS & rocket concerns.

Published

on

SpaceX-Ax-4-mission-iss-launch-date
(Credit: SpaceX)

SpaceX is preparing for a new launch date for the Ax-4 mission to the International Space Station (ISS).

SpaceX, Axiom Space, and NASA addressed recent technical challenges and announced a new launch date of no earlier than Thursday, June 19, for the Ax-4 mission. The delay from June 12 allowed teams to assess repairs to small leaks in the ISS’s Zvezda service module.

NASA and Roscosmos have been monitoring leaks in the Zvezda module’s aft (back) segment for years. However, stable pressure could also result from air flowing across the hatch seal from the central station. As NASA and its partners adapt launch schedules to ensure station safety, adjustments are routine.

“Following the most recent repair, pressure in the transfer tunnel has been stable,” a source noted, suggesting the leaks may be sealed.

“By changing pressure in the transfer tunnel and monitoring over time, teams are evaluating the condition of the transfer tunnel and the hatch seal between the space station and the back of Zvezda,” the source added.

Advertisement
https://www.teslarati.com/spacex-axiom-space-diabetes-research-iss/

SpaceX has also resolved a liquid oxygen leak found during post-static fire inspections of the Falcon 9 rocket, completing a wet dress rehearsal to confirm readiness. The Ax-4 mission is Axiom Space’s fourth private astronaut trip to the ISS. It will launch from NASA’s Kennedy Space Center in Florida on a Falcon 9 rocket with a new Crew Dragon capsule.

“This is the first flight for this Dragon capsule, and it’s carrying an international crew—a perfect debut. We’ve upgraded storage, propulsion components, and the seat lash design for improved reliability and reuse,” said William Gerstenmaier, SpaceX’s vice president of build and flight reliability.

The Ax-4 mission crew is led by Peggy Whitson, Axiom Space’s director of human spaceflight and former NASA astronaut. The Ax-4 crew includes ISRO astronaut Shubhanshu Shukla as pilot, alongside mission specialists Sławosz Uznański-Wiśniewski from Poland and Tibor Kapu from Hungary. The international team underscores Axiom’s commitment to global collaboration.

The Ax-4 mission will advance scientific research during its ISS stay, supporting Axiom’s goal of building a commercial space station. As teams finalize preparations, the mission’s updated launch date and technical resolutions position it to strengthen private space exploration’s role in advancing space-based innovation.

Advertisement
Continue Reading

Trending