

News
SpaceX installs first high-altitude Starship’s nosecone
For the first time ever, SpaceX has stacked a flightworthy Starship prototype to its full height, leaving just one major step to go before the rocket will be tasked with an unprecedented 15 km (~50,000 ft) flight test.
On October 21st, after much anticipation, SpaceX joined the first flightworthy Starship nosecone with a stack of five structural steel rings, reinforced with longitudinal beams known as stringers. Already affixed to a steel work stand, SpaceX then installed the completed nose section on a self-propelled mobile transporter (SPMT) and rolled the assembly roughly two miles from the Boca Chica factory to dedicated launch and test facilities.
Just one day prior, Starship serial number 8 (SN8) – the first prototype to be outfitted with flaps since Starship Mk1 – successfully ignited three Raptor engines for the first time ever, marking an immeasurably important milestone for both the vehicle and engine. Now, on October 22nd, SpaceX has successfully stacked the rocket to its full height, installing the just-finished nose section to effectively complete the first flightworthy ~50m (~165 ft) tall Starship prototype.
In the ~24 hours between the Starship SN8 nosecone’s pad arrival and installation on the rocket’s tank and engine section, the 24/7 LabPadre stream managed to catch a duo of apparent reaction control system (RCS) thruster tests. Perhaps more importantly, SpaceX also appeared to perform an ambient temperature pressure test, seemingly verifying that the small liquid oxygen header tank at the tip of the nosecone was leak-free and working as expected.
Curiously, hours prior to nose installation, SpaceX apparently removed one of Starship SN8’s three Raptor engines while also revealing that a spare fourth engine was already in Boca Chica. In other words, the prototype likely has only two Raptor engines installed at the moment, meaning that SpaceX will need to install another before the company can prepare for SN8’s next major test campaign.
According to CEO Elon Musk, the plan was to static fire Starship SN8’s three Raptor engines, perform final inspections and checkouts, perform another static fire, and finally attempt the first high-attitude Starship flight test. As of October 22nd, SpaceX has seemingly completed the two steps. Nosecone freshly installed, it’s likely that SpaceX will use the second triple-Raptor static fire opportunity to test the engines while feeding propellant solely from Starship’s liquid oxygen and methane header tanks – the latter of which is located in the nose.
If successful, that second static fire will open the Starship SN8’s flight debut, in which the massive rocket will attempt to fly to 15 km (50,000 ft), plummet back to Earth like a skydiver (belly-down), and perform a radical rocket-powered flip maneuver before landing in one piece beside the launch pad. Depending on how long it takes to firmly affix SN8’s nosecone to the rest of the rocket, that static fire could easily be less than a week away, followed by Starship’s most important flight test yet less than a week after that.
News
Tesla is preparing to take on autonomy’s final boss
India’s city streets are notorious for their complexity and congestion.

If there is any sign that Tesla is now confident about its self-driving program, it would be this. As could be seen on Tesla’s Careers page, the company is now hiring Autopilot Vehicle Operators in Delhi and Mumbai, India.
As far as real-world traffic is concerned, one could argue that India’s city streets are the final boss of autonomous driving systems due to their complexity and congestion.
Tesla job openings
As per Tesla in its recent job openings, Prototype Vehicle Operators will be responsible for driving an engineering vehicle for extended periods and conducting dynamic audio and camera data collection for testing and training purposes. In both its job listings for Mumbai and Delhi, Tesla noted that successful applicants will be gathering real-world data on the weekends and around the clock.
Considering the job openings in India, Tesla seems to be intent on rolling out its advanced driver-assist systems like FSD in the country. This is quite interesting, as Tesla is not hiring Prototype Vehicle Operators in other territories that recently launched, such as the Philippines. Perhaps Tesla intends to tackle FSD’s final boss of sorts before rolling out FSD in other territories.
FSD’s rollout
Tesla’s autonomous driving program uses the company’s Full Self-Driving system, which is currently available on vehicles in North America and China. Tesla, however, has a more advanced version of FSD called Unsupervised FSD, which is currently being used in vehicles that are part of the Robotaxi pilot in Austin and the Bay Area.
Elon Musk has also recently announced on X that Tesla will be releasing FSD V14 in the coming weeks. He also shared a number of improvements that can be expected from FSD V14. “The FSD release in about 6 weeks will be a dramatic gain with a 10X higher parameter count and many other improvements. It’s going through training & testing now. Once we confirm real-world safety of FSD 14, which we think will be amazing, the car will nag you much less,” Musk wrote in his post.
News
Tesla Sweden finally makes IF Metall union give up 600-day strike
Tesla and the union have opened the door to resolutions that do not involve a collective agreement.

After nearly two years of industrial action and sympathy strikes, Swedish labor union IF Metall has stated that it is softening its stance in its dispute with Tesla. With this, Tesla and the union have opened the door to resolutions that do not involve a collective agreement.
Union chair Marie Nilsson told Sveriges Radio’s Ekot that while the preferred outcome remains a signed agreement, “other alternative solutions” are now on the table.
Union reconsiders rigid demands
The strike, which began over 600 days ago, has been marked by a series of strategic moves from both sides. IF Metall blocked Tesla’s access to license plates by targeting mail delivery, while Tesla bypassed the restrictions by importing vehicles in bulk through German ferries to Trelleborg, among other strategies.
Despite the high-profile tactics, the number of active strikers has been relatively small, just about 60 in total, as noted in a CarUp report. Tesla Sweden has also maintained that it does not intend to bow down to the union’s demands. Over the 600-day strike, Tesla Sweden has adapted its operations to get around the union and its allies’ strikes.
Possible paths to ultimate resolution
Nilsson, for her part, noted that IF Metall is now willing to explore alternatives, such as embedding industry-standard terms directly into Tesla’s employment contracts or shifting Tesla’s Swedish operations to a company that already has a collective agreement.
“You can do it in different ways. The easiest thing would be to sign a collective agreement. But when that is not possible, we have to find other alternative solutions as well, so we are open to discussion,” Nilsson stated.
IF Metall, if any, has acknowledged that Tesla has already improved working conditions in Sweden since the dispute began. Tesla Sweden has argued that its working conditions are already better than union standards, which is reportedly one of the reasons why very few company employees actually participated in IF Metall’s strike.
“There have been conversations throughout the journey where we compared our conditions. Tesla has adjusted details without going into details, they want to be a good employer, it’s about wages and conditions,” Nilsson stated.
Cybertruck
Tesla Cybertruck is getting a big security upgrade
“Cybertruck was not 100% carryover in execution like S3XY, so it required work.”

Tesla confirmed today that a massive Cybertruck security feature is on the way soon, and it is one that owners have been asking about for a long time.
Like all Teslas, Cybertruck has the excellent security feature known as “Sentry Mode.” The feature essentially turns your Tesla into a moving security camera, recording any event that happens nearby.
It has been used to solve crimes such as vandalism and burglary, and even used by police departments to solve other, high-profile crimes.
Tesla quietly added this extra Sentry Mode feature to deter vandals
However, Cybertruck has been missing one key feature of Sentry Mode: the use of the B-Pillar camera has not been enabled, leaving one of the most vandalized and targeted vehicles in the United States with a weakness.
One person who has been vocal about it is Tesla Cybertruck enthusiast Greggertruck, who has been pushing for answers for months. He finally got his answer from Cybertruck Vehicle Program Manager Siddhant Awasthi:
“It will come soon! Cybertruck was not 100% carryover in execution like SX3Y so it required work. Team has finished work on this and just need to make sure it’s validated and runs reliably (which it should for its feature).”
It will come soon! Cybertruck was not 100% carryover in execution like SX3Y so it required work. Team has finished work on this and just need to make sure it’s validated and runs reliably (which it should for its feature)
— Siddhant Awasthi (@siddawa) August 14, 2025
It sounds as if Tesla’s issue was something they similarly experienced when deploying Full Self-Driving to Cybertruck. The other four Tesla vehicles were able to use FSD because they’re all relatively similar in ride height and overall functionality. They share tons of similarities.
Cybertruck did not get FSD right away because Tesla still had to work on the differences between it and the other cars in the lineup. As Awasthi said, “Cybertruck was not 100% carryover in execution like S3XY, so it required work.”
Tesla Cybertruck FSD release expected for Sept, Park Assist to come first
It sounds as if Tesla is close to resolving some of the more intricate details of adding the functionality, and it was just a matter of time before it figured out the issue.
The release of the B-Pillar camera being active during Sentry Mode events on Cybertruck will likely come in a software update in the coming weeks.
-
Elon Musk1 week ago
Elon Musk teases crazy new Tesla FSD model: here’s when it’s coming
-
Elon Musk6 days ago
Elon Musk confirms Tesla AI6 chip is Project Dojo’s successor
-
News6 days ago
Tesla Model Y L reportedly entered mass production in Giga Shanghai
-
Elon Musk7 days ago
Tesla CEO Elon Musk details massive FSD update set for September release
-
Cybertruck6 days ago
Tesla’s new upgrade makes the Cybertruck extra-terrestrial
-
News4 days ago
Elon Musk reaffirms Tesla Semi mass production in 2026
-
Elon Musk1 week ago
Tesla ‘activist shareholders’ sue company and Elon Musk for Robotaxi rollout
-
News1 week ago
Elon Musk explains why Tesla stepped back from Project Dojo