Connect with us
tesla pedestrian noisemaker tesla pedestrian noisemaker

News

Tesla plans to retrofit its pedestrian warning system in older vehicles

Pedestrian noisemaker on the Tesla Model 3.(Photo: Erik Strait/Instagram)

Published

on

Tesla is reportedly planning to retrofit its Pedestrian Warning System (PWS) into older Model 3s and Model Ys that were built between specific dates.

For those who aren’t aware, Tesla was required to create and install a PWS in its vehicles due to an NHTSA mandate that set requirements for electric vehicles to make noise when traveling at a speed below 19 MPH. The reasoning was based on the safety of pedestrians who would be walking near an electric vehicle. Due to the lack of a combustion engine in an EV, the cars are extremely quiet when traveling at low rates of speed. While great for noise pollution, it can be somewhat dangerous to pedestrians, especially ones who have vision issues or are blind. The mandate was established by the NHTSA with the Pedestrian Safety Enhancement Act of 2010, and all EV makers had until September 1, 2020, to install noisemakers on their vehicles.

First look at Tesla Model 3’s pedestrian noisemaker in action

In typical Tesla fashion, the company didn’t wait until the mandate was required and took action immediately. Model 3s delivered to customers in early September 2019 were outfitted with the noisemaker. An employee of the automaker also stated that all Model 3s built on September 1, 2019, and after would automatically be equipped with the noisemaker. Tesla Owners Online founder and Model 3 owner Trevor Page initially spoke to the employee who confirmed the presence of the Model 3 noisemaker in September 2019.

Page has now also confirmed with a Tesla source that the PWS can be retrofitted in Model 3 vehicles built between July 5, 2019, through September 9, 2020. Page said on his original posting that “this period represents the timing of when the wiring harness was included but not the speaker.” Page added that Model Ys built before August 14th also qualify and that the cost will be $200. It will require a mobile and service visit, and a technician must install it so that the car can identify it.

Advertisement

“Refer to Tesla SI-21-90-001 when you make an appointment to have it installed for reference,” Page advised.

Page also broke the story of the noisemakers being installed in late 2019.

The retrofit for the PWS isn’t all about safety, though. It also holds some entertainment benefits. The speaker is utilized by Tesla’s Boombox feature that was added with the Version 10 Software. This allows owners to play sounds audibly for those outside the vehicle to hear, and custom noises have become quite the buzz on some social media outlets like TikTok, where Tesla owners show the vast array of audio selections that they choose to play for spectators. Musk considered this addition in late 2020, and it appears that Service techs will now install the external speaker for those vehicles that qualify.

Advertisement

Will you equip your vehicle with the PWS? Let us know in the comments if you will or won’t, and explain your decision. You can also reach me personally at joey@teslarati.com or @KlenderJoey on Twitter.

Joey has been a journalist covering electric mobility at TESLARATI since August 2019. In his spare time, Joey is playing golf, watching MMA, or cheering on any of his favorite sports teams, including the Baltimore Ravens and Orioles, Miami Heat, Washington Capitals, and Penn State Nittany Lions. You can get in touch with joey at joey@teslarati.com. He is also on X @KlenderJoey. If you're looking for great Tesla accessories, check out shop.teslarati.com

Advertisement
Comments

News

SpaceX aces Starship test flight 10 with successful payload deployment

The mission began at 6:30 p.m. local time in Starbase, Texas, when the launch of Starship initiated. After about eight minutes, stage separation was completed, and the Super Heavy Booster headed back down to Earth for a planned splashdown in the Indian Ocean:

Published

on

Credit: SpaceX

SpaceX aced its tenth Starship test flight on Tuesday night after multiple delays pushed the mission back to this evening. Originally scheduled for Sunday night, SpaceX had two delays push the flight back to Tuesday, which ultimately provided ideal conditions for a launch attempt.

The tenth test flight of Starship had several objectives, including a successful splashdown of the booster in the Gulf of America, the deployment of eight Starlink simulation modules from the PEZ dispenser, and a splashdown of the ship in the Indian Ocean.

SpaceX Starship Flight 10: What to expect

SpaceX successfully achieved all three of these objectives, making it one of the most successful test flights in the Starship program. There was no attempt to catch the booster this evening, as the company had been transparent about it ahead of the launch.

The mission began at 6:30 p.m. local time in Starbase, Texas, when the launch of Starship initiated. After about eight minutes, stage separation was completed, and the Super Heavy Booster headed back down to Earth for a planned splashdown in the Indian Ocean:

Advertisement

Starship was then the main focus of the rest of the broadcast as it completed its ascent burn and coasted through space, providing viewers with spectacular views as the mission headed toward new territory, including the deployment of Starlink simulators. This would be the first time SpaceX would attempt a payload deployment.

The deployment works like a PEZ dispenser, as the simulators were stacked on top of one another and would exit through a small slit one at a time.

This occurred roughly 20 minutes into the mission:

Advertisement

An hour and six minutes into the flight, Starship reached its final destination, which was the Indian Ocean. A successful splashdown would bring closure to Starship’s tenth test flight, marking the fifth time a test flight in the program’s history did not end with vehicle loss.

It was also the first of four test flights this year that will end with Starship being recovered.

Advertisement

SpaceX is expected to launch Starship again in approximately eight weeks, pending the collection of data and other key metrics from this flight.

Continue Reading

News

WATCH: SpaceX attempts Starship’s tenth test flight after two delays

This evening, SpaceX has already stated that conditions appear to be approximately 45 percent favorable for launch. This is ten percent less than last night, when the mission was eventually scrapped around 7 p.m. local time.

Published

on

Credit: SpaceX

SpaceX is set to launch Starship tonight, provided the weather cooperates and everything with the ship goes smoothly.

This is SpaceX’s third attempt to launch Starship for its tenth test flight, with Sunday’s and Monday’s attempts both being scrapped due to a leak and unfavorable weather conditions on the respective days.

This evening, SpaceX has already stated that conditions appear to be approximately 45 percent favorable for launch. This is ten percent less than last night, when the mission was eventually scrapped around 7 p.m. local time.

SpaceX Starship Flight 10: What to expect

Propellant load of the upper stage and Super Heavy booster is already underway, and the launch is expected to occur at 6:30 p.m. in Starbase, Texas.

Advertisement

You can watch the tenth test flight of Starship below via SpaceX:

Continue Reading

News

Tesla one-ups Waymo once again with latest Robotaxi expansion in Austin

Tesla’s new Robotaxi geofence measures roughly 171 square miles of Austin’s downtown and suburbs. This is more than double the size of Waymo’s geofence, which measures 90 square miles.

Published

on

Credit: @BLKMDL3 | X

Tesla’s expansion of the Robotaxi geofence on Tuesday morning was a one-up on Waymo once again, as the automaker’s service area growth helps eclipse its rival in an intense back-and-forth.

A lot of conversation has been made about Tesla’s rivalry with Waymo in terms of the capabilities of its driverless ride-sharing service in Austin, Texas.

The two companies have sparred with one another, answering each other’s expansion, and continuing to compete, all to the benefit of consumers in the region.

Tesla expanded the geofence of Robotaxi once again this morning, and it is another growth that catapults it past Waymo’s service area in Austin — this time by a considerable margin.

Tesla’s new Robotaxi geofence measures roughly 171 square miles of Austin’s downtown and suburbs. This is more than double the size of Waymo’s geofence, which measures 90 square miles.

On July 14, Tesla officially overtook Waymo in terms of service area in Austin. But just a few days later, Waymo had responded with a bold statement, expanding from 37 square miles to 90 square miles.

Sarfraz Maredia, Global Head of Autonomous Mobility & Delivery at Uber, said the move “unlock[ed] another key milestone in Austin as our operating territory with Waymo expands from 37 to 90 square miles, which means that even more riders can experience Waymo’s fully autonomous vehicles through the Uber app.”

Advertisement

Tesla did not respond immediately, but it took its time with validation vehicle testing in the Austin suburbs, as we reported yesterday:

Tesla looks to expand Robotaxi geofence once again with testing in new area

Today’s expansion is perhaps the biggest step Tesla has taken in its efforts to continue to grow its Robotaxi platform. This is not only because the company has significantly expanded the size of the geofence, but also because it has ventured into suburban areas and even included Gigafactory Texas in its service area.

Waymo could come up with another timely response as it did when Tesla expanded in late July. We’ll wait to see what it comes up with, as this awesome competition between the two companies is accelerating innovation.

Advertisement
Continue Reading

Trending